Replacing The Lamp; Closing The Door; Technical Data - AEG FRIDGE-FREEZER User Manual

Problem
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.

Replacing the lamp

1. Switch off the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of the
arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the lamp cover).
4. Install the lamp cover by sliding it into its
original position.
5. Switch on the appliance.
6. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Height
Width
Depth
Technical data
Solution
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
1780 mm
560 mm
550 mm
21 h
230-240 V
50 Hz
15