Advertisement
0
7
IMPORTANT
FOR SAFETY
CONNECT TO ELECTRICAL POWER AND GROUND
WARNING:
BE SURE
ELECTRICAL
POWER
IS TURNED
OFF
AT
CIRCUIT
BREAKER.
A-Remove
junction
box from
dishwasher.
B-Install
approved
connector
(not furnished).
C-Connect
power cable white
lead to white lead and black
lead to black lead with
adequate
insulation
or wire nuts and ground wire
under green ground screw or lug. Reinstall
junction
box,
When house wiring
is aluminum,
use U.L. approved
aluminum
to copper
connectors.
The dishwasher
must be properly
grounded
before operating
by connecting
the chassis ground lug terminal
to a suitable ground complying
with National
Electrical
Code and/or local electrical
code.
FIG.
7
0
8
TESTING INSTALLATION
Remove
installation
debris from
under dishwasher,
foam door pads on each side and near top
of tank, and all internal
packing
material
and labels. NOTE:
Do not remove white plastic glides
on sides of door or white plastic bumpers on front corners of lower rack.
Custom and Imperial
Models
Close door and latch handle. Turn on electri-
cal and water supplies.
Turn Cycle Selection
Dial clockwise
until it clicks in "Heavy Wash"
position.
Push
"Heavy
Wash"
button
and
allow
dishwasher
to run through
the com-
plete
cycle
to make certain
it is operating
properly.
Turn
off
electrical
power,
remove
lower
panel
and check
for leaks. Reinstall
lower
panel
and turn
on electrical
power.
Patrician
and Superba Models
Close
door
and latch
handle.
Press "Cancel
Cycle"
button;
timer
will
automatically
advance
to off.
Lift
door
handle
and wait
for timer
to reset itself.
Latch door handle
and press "Heavy
Wash"
button.
Run dish-
washer through
the complete
cycle to make
certain
it
is operating
properly.
Turn
off
electrical
power,
remove
lower
panel
and
check
for
leaks.
Reinstall
lower
panel and
turn on electrical
power.
Advertisement
