Foxconn H81MXV Series User Manual page 22

front Panel Header: fP
This motherboard includes one connector for
connecting the front panel switch and LED
Indicators.
Hard Disk LeD Connector (HDD-LeD)
Connect to the chassis front panel IDE
indicator LED. It indicates the active status
of the hard disks. This 2-pin connector is
directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the
front panel of the case; the system will restart
when the switch is pressed.
Power LeD Connector (PWR-LeD)
Connect to the power LED indicator on the
front panel of the chassis. The Power LED
indicates the system's status. When the
system is in operation (S0 status), the LED is
on. When the system gets into sleep mode (S1)
, the LED is blinking; When the system is in
S3/S4 sleep state or power off mode (S5), the
LED is off. This 2-pin connector is directional
with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front
panel of the chassis. Push this switch allows
the system to be turned on and off rather than
using the power supply button.
Audio Header: f_AUDIO
The audio header supports HD Audio standard. It
provides the Front Audio output choice.
Serial ATA 3.0 Connectors: SATA_1/2
These connectors are used to connect with SATA
3.0 Hard Disk drives.
Serial ATA 2.0 Connectors: SATA_3/4
These connectors are used to connect with SATA
2.0 Hard Disk drives or optical disc devices.
HARDWARE INSTALLATION
1 2
+ +
HDD-LED PWR-LED
-
-
RESET-SW
PWR-SW
EMPTY
NC
9 10
FP
1 2
A_MIC2_L AUD_GND
A_MIC2_R
PRESENCEJ
A_LINE2_R
SENSE1_RETURN
SENSE_SEND
EMPTY
SENSE2_RETURN
A_LINE2_L
9 10
F_AUDIO
1
GND
TX+
TX-
GND
RX-
RX+
GND
SATA_1/2 SATA_3/4
1
GND
TX+
TX-
GND
RX-
RX+
GND
15