Warnings And Precautions - BRAVILOR BONAMAT Mondo TH Operating Instructions Manual

1.3 Warnings and precautions

The following warnings and precautions
must be observed to safeguard the safe
use of the coffee making machine:
W
ARNINGS
∆ Never immerse the machine in water.
∆ Remain in the vicinity of the machine
during maintenance activities, such as
descaling.
∆ Ensure the flex does not touch the
heating plate.
∆ The machine must always be
connected to the electrical mains so
that all wires are easy to separate from
the mains.
∆ The manufacturer accepts no liability
for damage resulting from installation,
use or maintenance activities that are
not described in these operating
instructions.
∆ Some parts of the equipment will
become very hot during use.
P
RECAUTIONS
• If the equipment is not used for a long
period, it is recommended to
disconnect it from the mains.
• It is normal for some water to remain in
the machine. This should be taken into
account if the machine is moved to a
location where the temperature may
fall below 0 °C.
2
• If all the water has been removed from
the machine, the instructions for
"Installation and operation" should be
carried out again.
• If you use a strong cleaner or descaler,
it is highly recommended to wear
safety goggles (face protection) and
gloves.
• Avoid spilling any descaling solution on
the outside of the machine since this
may result in permanent damage to
the housing. However, should descaler
come into contact with the outside of
the machine, this must be removed as
quickly as possible by observing the
safety precautions described in these
operating instructions. The point of
contact must immediately be cleaned
thoroughly.
• Always wash your hands after using a
strong cleaner or descaler.
• Have all repair work carried out by a
specialist service engineer.
• In the case of repair and/or
maintenance activities in which the
machine must be opened, all wires
including the earth wire must be
disconnected from the mains.
• The machine must have an earth
connection.
• Always use approved materials and
components during installation.
• During the installation activities, always
observe local regulations and
standards.