Table of Contents
Advertisement
Provide power only when ignition switch is turned on.
Be aware of battery voltage. It is prohibited to connect to the
K530 when voltage is out of operating range.
(K530 operation voltage is 9~32V.)
Do not apply power to K530S when the starter motor is engaged.
The power management system should allow the K530S to remain
powered on for a period of time after the ignition is switched off
to prevent battery drain. This time is typically user programmable.
Power Management with Filter
The added part further conditions power voltage with the use of a
filter, which can further smooth out residual transients left over by the
power management block.
+
12V/24V
Battery
-
Ignition Switch
V in
V out
Enable
Power
Management
GND
Filter
8
Advertisement
Table of Contents
