Installation; Unpacking; Location Selection; Cable Connections - info-rise SunLight-206 User Manual

3.1 Unpacking

The UPS is packed and enclosed in a structural cardboard carton to protect it from damage.
1. Inspect for damage that may have occurred during the shipment If any damage is noted, call the
shipper immediately and retain the shipping carton and the UPS.
2. Carefully open the carton and take the UPS out.
3. Retain the carton and packing material for future use.
Unit package contents :
User Manual
Guarantee Certificate
Battery Cabinet
Additional battery cabinet
UPS Monitoring Software
* O : Optional

3.2 Location Selection

The UPS is designed to be installed in a protected environment. The following conditions should be
prohibited.
1. Blocking the airflow intake and outlet. (It is recommended to retain 10 cm (4") minimum. Between the
rear side and the wall.)
2. Environment temperature and humidity out of specification.
3. Location subject to excessive moisture, dust and corrosion.
4. Location exposed to heat source or direct sunlight.

3.3 Cable Connections

Only qualified personnel should install or service UPS / batteries.
The ac input to the UPS should be supplied by a separate line from the ac distribution board.
The input/output cables can be sized to suit the modules rating according to the table below.
6 kVA
7,5 kVA
10 kVA
15 kVA
III. INSTALLATION
SL-206 SL-207
- -
O O
RUPS II RUPS II
CAUTION!
2
3 x 6 mm and 4 mm
2
3 x 6 mm and 4 mm
2
3 x 6 mm and 4 mm
2
3 x 10 mm and 4mm
SunLight Series UPS User Manual
SL-210 SL-215
-
O O
RUPS II RUPS II
2
Eart Cable
2
Eart Cable
2
Eart Cable
2
Eart Cable
SL-220 SL-230
- -
O O
RUPS II RUPS II
7