Advertisement
15.
Remove the tape from one side of the artwork using caution
NOT to tear the artwork or mesh.
It is at this point you should check the design for correct imaging.
•
Peel back only a small area of the design
•
If re-imaging is required you must reattach the side and head to
the artwork (steps 4-7) before running through the machine
16.
After checking your screen remove the fi nal piece of tape from
the back of the artwork.
17.
Remove the artwork from the design
18.
You will note 3 creases on your mesh outside the artwork area
caused by compression as the mesh was passed through the
machine. Simply mount to a frame in the normal process.
•
The crease is outside the print area and will not effect your print
result, it is simply a cosmetic issue and should be ignored, as
it is part of the oversized imaging process.
•
Do not try to 'pull out' the crease when mounting to a frame -
you will distort your design and may damage the mesh
Cleaning
Keeping your machine clean will ensure an ongoing trouble free operation. Above all avoid dusty
locations (see Machine Location on Page 3 for more details) and keep the Glass Roller clean.
Machine
Clean carefully using moistened cotton swab with small amount of washing up liquid.
•
Do not wet tables or rear electrical power plug
Glass Roller
Clean regularly by depressing the 'Feed' button (see page 3) and wiping with Isopropyl alcohol.
Carriers
Wipe carrier immediately after use with lint free cloth and return to protective cover.
Replace if cover worn, damaged, marked, bent or results begin to deteriorate.
Troubleshooting
Problems
Green LED doesn't light:
Main switch set to "0"
Power cord not properly connected
Electrical unit inside the machine defect
The heat lamp doesn't work, but green LED lights up:
High temperature inside the machine -
protective thermal sensor has activated
Lamp is defect/ broken
Fuse of the lamp is broken
After copying, motor and fans continue to work:
Normal operation: motor runs for 5 minutes,
fans fun for 10 minutes after the last copy
Originals are jammed:
No carrier or the wrong carrier was used.
Carrier does not bear the heat.
Additional Troubleshooting, How to and Support - http://www.thermal-copier.com/support
Set to "I"
Connect to a suitable electrical outlet
Contact service offi ce on (02) 9979 9700
Heat sensor activated. Wait up to 20 minutes
for the machine to cool
Contact sales offi ce for replacement
Replace with same type and value
Do not switch off the machine.
Cooling is in progress./
Always use a carrier. Models CS04 (tefl on
cover) and R-TCA4 (budget cover)
9
© 2008 NEHOC Australia Pty Ltd
Step 15
Step 18
Solutions
Advertisement
