Chevrolet 2012 Corvette Navigation System User Manual page 21

3. Press RDS ON/OFF to turn
RDS on.
4. Press PTY.
5. Press Select PTY and select the
desired PTY from the list.
6. Press and hold one of the
six presets for more than
two seconds until a beep is
heard. When you press that
numbered preset for less than
two seconds, the set PTY
returns.
7. Repeat the steps for each
preset.
Press the stored PTY preset station
for less than two seconds to recall
r
it. Then use SEEK
SCAN to locate a station for that
PTY selection.
ALERT: This type of
announcement warns of national
or local emergencies and cannot
be turned off. ALERT displays
while an alert announcement plays.
The audio system uses TA volume
during these announcements.
To increase volume, use the
VOL up and down buttons during
the announcement. See Voice
Guidance Volume Settings under
Navigation Set Up on page 61 for
more information. When an alert
announcement comes on the tuned
radio station it will be heard even
if the volume is muted or a CD
is playing. If the CD player is
playing, the player stops for the
announcement and resumes when
q
or
the announcement is finished.
Infotainment System
Home and Away Preset
Stations
If the vehicle has this feature, the
audio system settings that were
adjusted the last time the vehicle
was operated can be recalled.
This feature allows two different
drivers to store and recall their own
audio system settings. The adjusted
settings are recalled by the audio
system and are determined by
which Remote Keyless Entry (RKE)
transmitter (1 or 2) that was used to
enter the vehicle. The number on
the back of the RKE transmitter
corresponds to driver 1 or to
driver 2.
21