Making Connections; Enabling The Computer's External Display; Connecting Your Pc Or Macintosh Computer - NEC VT580 User Manual

Making Connections

NOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby mode
and before turning on the power to the notebook PC.
In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered
up.
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power
management software.

Enabling the computer's external display

Displaying an image on the notebook PC's screen does not necessarily mean it outputs a signal to the projector.
When using a PC compatible laptop, a combination of function keys will enable/disable the external display.
Usually, the combination of the 'Fn" key along with one of the 12 function keys gets the external display to come on or
off. For example, NEC laptops use Fn + F3, while Dell laptops use Fn + F8 key combinations to toggle through
external display selections.

Connecting Your PC or Macintosh Computer

NOTE: • VT580/VT480: The COMPUTER 1 connector supports Plug & Play (DDC2).
• VT58/VT48: The COMPUTER connector supports Plug & Play (DDC2).
S-VIDEO
Audio cable
(not supplied)
IBM VGA or Compatibles (Notebook
type) or Macintosh (Notebook type)
NOTE: The projector is not compatible with video decoded outputs of either the NEC ISS-6020 and ISS-6010 switchers.
NOTE: An image may not be displayed correctly when a Video or S-Video source is played back via a commercially available scan
converter.
This is because the projector will process a video signal as a computer signal at the default setting. In that case, do the following.
* When an image is displayed with the lower and upper black portion of the screen or a dark image is not displayed correctly:
Project an image to fill the screen and then press the AUTO ADJ button on the remote control or the projector cabinet.
Downloaded From projector-manual.com NEC Manuals
VT580/VT480
COMPUTER 1 IN
PC CONTROL MONITOR OUT(COMP 1)
COMPUTER 1 IN
L AUDIO IN
IN
COMPUTER 2 IN
AUDIO OUT
R
VIDEO IN AUDIO IN AUDIO IN
PHONE
COMPUTER 2 IN
VGA signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It is
recommended that you use a commercially available
distribution amplifier if connecting a signal cable longer
than the supplied one.
NOTE: For older Macintosh, use a commercially available
pin adapter (not supplied) to connect to your Mac's
video port.
13
2. Installation and Connections
VT58/VT48
COMPUTER IN
PC CONTROL MONITOR OUT
S-VIDEO L COMPUTER IN
IN
R
VIDEO IN AUDIO IN