Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kenwood KAC-6402
Summary of Contents for Kenwood KAC-6402
- Page 1 4/3/2 CHANNEL POWER AMPLIFIER KAC-6402 INSTRUCTION MANUAL © B64-3047-00/00 (MV)
-
Page 2: Safety Precautions
• To prevent a short circuit when replacing a fuse, first disconnect the wiring harness. NOTE • If you experience problems during installation, consult your Kenwood dealer. • If the unit does not seem to be working right, consult your Kenwood dealer. English... -
Page 3: Installation
Installation Self-tapping screw (ø4 × 16 mm) Installation board, etc. (thickness : 15 mm or more) CAUTION • Do not install in the below locations; (Unstable location, In a location that interferes with driving, In a location that gets wet, In a dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air) •... - Page 4 Controls / Indicator 1 FILTER switch (A.ch/B.ch) 5 INPUT SENSITIVITY control (A.ch/B.ch) This switch allows to apply high-pass or low-pass Set this control according to the pre-output level filtering to the speaker outputs. of the center unit connected with this unit, or to the maximum power output of the genuine- •...
- Page 5 English...
- Page 6 Connection English...
-
Page 7: Installation Procedure
■ Installation procedure ■ Wiring Since there are large variety of settings and • Take the battery wire for this unit directly from the connections possible according to applications, read battery. If it's connected to the vehicle’s wiring the instruction manual well to select the proper harness, it can cause blown fuses etc. -
Page 10: System Examples
System examples English... - Page 11 English...
-
Page 12: Troubleshooting Guide
Troubleshooting Guide What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. PROBLEM POSSIBLE CAUSE SOLUTION No sound. • Input (or output) cables are •... -
Page 13: Specifications
Specifications Specifications subject to change without notice. Audio Section Max Power Output .......................................400 W Rated Power Output Normal (4 Ω) (20 Hz – 20 kHz, 0.08 % THD) ...........................35 W x 4 Normal (2 Ω) (1 kHz, 0.8 % THD) ................................50 W x 2 Bridged (4 Ω) (1 kHz, 0.8 % THD) ...............................