3Jtech HSPA FWT WiFi AP Quick Setup Manual

Ver 1.0.0.3

Quick Setup Guide for HSPA FWT WiFi AP

1. HSPA FWT WiFi AP Packing List :

Before you start installing the HSPA FWT WiFi AP, please verify that the package contains the

following items:

One Set of HSPA FWT WiFi AP,

1x RJ45 Network Cable,

External 3G Antenna with 3M Antenna Cable,

RJ11 Phone Cable,

1x Power Adapter,

CD with User's Manual,

This Quick Setup Guide

NOTE: Please notify your sales representative immediately if any items listed above is missing or damaged.

1) Connect PC to LAN port of your HSPA FWT WiFi AP using a RJ-45 cable.

2) Make sure the SIM card has inserted to the modem, and the modem is ready as well.

3) Connect the power cable to the power connector of your HSPA FWT WiFi AP.

4) For using the Fixed Wireless Terminal (FWT) function, connect an analog phone to the

PHONE port of your HSPA FWT WiFi AP using a RJ-11 cable.

Fig.1 The Connection of HSPA FWT WiFi AP

Since 1988

Table of Contents

Do you have a question about the HSPA FWT WiFi AP and is the answer not in the manual?

Page 1 Quick Setup Guide for HSPA FWT WiFi AP 1. HSPA FWT WiFi AP Packing List : Before you start installing the HSPA FWT WiFi AP, please verify that the package contains the following items: One Set of HSPA FWT WiFi AP,...
Page 2 Ver 1.0.0.3 Since 1988 3. LED Description of the Rear Panel Color Status Yellow Lit when +8V DC power is on and working. POWER( Lit when the cable connection with device exists. Yellow Flash when the data is transmitting. LAN Link ( Off when no cable connection exists.
Page 3 Since 1988 4. Software Connection Settings Refer to the following sections to set up the HSPA FWT WiFi AP. Before the setup, please confirm that the LAN port of the AP has been connected with the PC via RJ-45: Set up 3G Settings for the HSPA FWT WiFi AP Please connect your computer to the HSPA FWT WiFi AP’s LAN port.
Page 4: Restore Factory Default Settings
5. Restore Factory Default Settings HSPA FWT WiFi AP provides a “RESET” button that will be easy for users to reset the AP to default. The button is located at the front panel of the AP (See the figure below). Reset steps are as follows: (1) Press the RESET button 2 seconds around.