Hayward HLWLAN 802.11b/g/n Owner's Manual

Hayward HLWLAN 802.11b/g/n Owner's Manual

Transceiver kit, wireless communications for omnilogic

Advertisement

Quick Links

092524 RevB
HLWLAN 802.11b/g/n
Transceiver Kit
Wireless Communications for OmniLogic
Owner's Manual
Contents
Introduction.......................1
Installation........................2
Configuration....................6
Operation..........................8
Troubleshooting.................9
Hayward Pool Products
620 Division Street, Elizabeth NJ 07207
www.hayward.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HLWLAN 802.11b/g/n and is the answer not in the manual?

Questions and answers

Summary of Contents for Hayward HLWLAN 802.11b/g/n

  • Page 1: Table Of Contents

    092524 RevB HLWLAN 802.11b/g/n Transceiver Kit Wireless Communications for OmniLogic Owner’s Manual Contents Introduction.......1 Installation......2 Configuration....6 Operation......8 Troubleshooting....9 HLWLAN Hayward Pool Products 620 Division Street, Elizabeth NJ 07207 www.hayward.com USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 2: Fcc Statement

    (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Hayward could void the user’s authority to operate this equipment.
  • Page 3: Introduction

    If a reliable wireless connection can’t be made in the intended location, consider moving the router/access point closer to the OmniLogic or using a longer outdoor rated ethernet cable to move the HLWLAN closer to the router/access point. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 4: Installation

    OmniLogic panel beneath the dead front. Dead front removal is required for this installation. Power to the OmniLogic panel MUST be shut off before the dead front is removed. This means a complete shutdown of power to the entire OmniLogic panel. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 5 You will need to refer to these indicators before permanently fastening the HLWLAN. Attach PoE injector power cable to connector labeled “HLWLAN Power” HLWLAN POWER 2) Connect the Power Injector’s power cable to the OmniLogic as shown above. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 6 Connect 2ft ethernet cable here 3) Connect one end of the 2ft ethernet cable to the OmniLogic as shown. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 7: Lan Port

    HLWLAN marked “LAN PoE”. To access this port, remove the HLWLAN’s bottom cover. Be sure to replace the cover when done. After all connections are made, replace the OmniLogic Dead Front taking care that no wires are pinched. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 8: Configuration

    POOL firmware restore config configuration config wizard display system info wired networking º heating themes POOL configuration favorites config º alarm lights daylight features USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 9 255.255.255.0 Gateway 192.168.10.1 DNS1 192.168.10.1 DNS2 0.0.0.0 service wired networking SYSTEM configuration firmware restore config config wizard display system info wired networking º heating themes POOL configuration favorites config º alarm lights daylight features USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 10: Operation

    After verifying an acceptable signal, secure the HLWLAN to the mounting surface. Operation After successfully installing the HLWLAN, you will need to setup a Hayward OmniLogic user account in order to remotely access the OmniLogic through the web using a standard internet browser or mobile app.
  • Page 11: Troubleshooting

    OmniLogic at any time from your browser by logging into your account at hay- wardomnilogic.com. For mobile devices, an app must be downloaded from your device’s app store. Go to www.hayward.com for more information on the availability and function of mobile apps.
  • Page 12 Hayward is a registered trademark and OmniLogic is a trademark of Hayward Industries, Inc. © 2013 Hayward Industries, Inc. All other trademarks not owned by Hayward are the property of their respective owners. Hayward is not in any way affiliated with or endorsed by those third parties.

Table of Contents