Replacing The System Board - Lenovo ThinkCentre 7515 Maintenance Manual

Replacing the system board

This section provides instructions on how to replace the system board.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and
wait three to five minutes to let the computer cool before removing the
computer cover.
Note: When replacing the system board, you must order a new retention module
To replace the system board:
10. Remove the microprocessor from the failing system board and install it on the
11. The failing system board must be returned with a microprocessor socket cover
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
for the new system board. Make sure you have a retention module for the
new system board before continuing this procedure.
1. Remove the computer cover. See "Removing the computer cover" on page 86.
2. Remove the primary hard disk drive with the hard disk drive cage. See
"Replacing the primary hard disk drive" on page 105.
3. Lay the computer on its side to make the system board more accessible.
4. Remove all memory modules and adapter cards that are currently installed.
See "Installing or replacing a memory module" on page 90 and "Installing or
replacing an adapter card" on page 92.
5. Carefully take note of the location of all cable connectors on the system board
and disconnect all the cables. See "Locating parts on the system board" on
page 89.
6. Remove the heat sink and fan assembly from the failing system board. See
"Replacing the heat sink and fan assembly" on page 98.
7. Remove the screws that secure the system board to the chassis.
8. Carefully move the system board out of the chassis.
9. Remove the microprocessor socket cover from the new system board.
new system board. See "Replacing the microprocessor" on page 100.
to protect the pins during shipping and handling. Install the microprocessor
socket cover removed from the new system board on the failing system board.
To install the microprocessor socket cover:
a. Make sure the microprocessor has been removed from the microprocessor
socket, and then close the microprocessor retainer and lock it into position
with the small handle.
Chapter 8. Replacing FRUs - Tamdhu computers
103