Zanussi ZD29/8DL3 User Manual page 4

Changing the opening direction
of doors and Panelling
If you wish to change the opening side of the doors
proceed as follows:
1... Remove the handles of the doors, if they are side
fixing by screws.
2... Take off the plinth pressed on to.
3... Remove the inferior hing taking care for the dow-
ner door not to fall off.
4... Lift the downer door off the central hinge.
5... Disassemble the lower hinge reinforcement «Z».
6... Remove the central hinge taking care for the upper
door not to fall off and not to lose the plastic spacer.
7... Take the upper door off the upper hinge. Be careful
not to lose the plastic ring.
8... Unscrew the plastic bolts of the opposite side of the
place of the central hinge taken out and introduce
them in the holes occupied before by the hinge.
9...Unscrew the axe of the upper hing and screw it to
the hinge on the opposite side. Make sure to fit in
the metal spacer for blocking.
Place upper door.
Assemble the lower hinge reinforcement in the
opposite side it was sitsuated. For the remaining
parts proceed the other way round.
Once finished make sure that all joints close
perfectly well all around the door and chek that the
internal light turns of when the fridge door closes.
How to panel the door:
If your appliance is provided with metal strips for
panelling and you wish to do so proceed as follows:
1... Remove one of the side strips.
2... Loosen the screws of the remaining strips.
3... Start putting on the panel where you took off the
strip pushing it right up to the end.
4... Replace the strip on this side.
5... Tighten all screws
NOTE: The panel dimensions must be 2 mm. shorter
than the doors. Maximun thickness of the panel is
4 mm.
18