Download Print this page

Crystal DBH05 Operating Instructions Manual

Uhf hand held 2 way citizen band radios

Advertisement

Quick Links

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Operating Instructions   
DBH05 – 80 Channel 0.5 watt UHF Hand held   
DBH20 – 80 Channel 2 watt UHF Hand held 
DBH09R ‐ 80 Channel 1 watt UHF Hand held with   
Rechargeable batteries and docking station 
2 way Citizen Band radios 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Advertisement

loading
Need help?

Need help?

Do you have a question about the DBH05 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Crystal DBH05

  • Page 1 Operating Instructions              DBH05 – 80 Channel 0.5 watt UHF Hand held    DBH20 – 80 Channel 2 watt UHF Hand held    DBH09R ‐ 80 Channel 1 watt UHF Hand held with    Rechargeable batteries and docking station    2 way Citizen Band radios                                                 ...
  • Page 2: Technical Assistance

    Technical Assistance    If you need assistance setting up or using your CRYSTAL product now or  in the future, call CRYSTAL Support.  Australia    TEL: 03 – 8587 8898  FAX: 03 – 8587 8866    Mon‐Fri 9am – 5pm AEST    Please retain this user guide for future reference. ...
  • Page 3: Safety Information And Warnings

    Safety Information and Warnings    Information on Safe Operation  Read This Information Before Using Your CRYSTAL Radio. The operation of your UHF radio in  Australia is subject to conditions in the following license:  In Australia the ACMA Radio communications (Citizen Band Radio Stations) and in New Zealand by  MED the General User Radio License for Citizen Band Radio.    Radio Antenna  Do not use any radio that has a damaged antenna. If a damaged antenna comes in contact with the  skin, a minor burn may result.  Unauthorized antennas, modifications, or attachments could damage the radio and violate  compliance. Do NOT change or modify the antenna.  Do NOT hold the antenna when the radio is “IN USE.” Holding the antenna reduces range and may  cause bodily harm.    Safety and general use whilst in a vehicle  Check the State and Federal laws and regulations regarding the use of two way radios in the area  where you drive, and always obey them.    For Vehicles fitted with Air Bags  Do not place your radio in the area over an air bag or in the air bag deployment area. Air bags  inflate with great force. If a radio is placed in the air bag deployment area and the air bag inflates,  the radio may be propelled with great force and cause serious injury to the occupants of the  vehicle.    Batteries  All batteries can cause property damage and/or bodily injury such as burns if conductive material  such as jewellery, keys, or beaded chains touches exposed terminals. The material may complete  an electrical circuit (short circuit) and become quite hot. Exercise care in handling any charged  battery, particularly when placing it inside a pocket, purse, or other container with metal objects.    Do not replace or charge batteries in a potentially explosive atmosphere. Contact sparking may  occur while installing or removing batteries and cause an explosion.    Potentially Explosive Atmospheres  Turn your radio OFF when in any area with a potentially explosive atmosphere. Sparks in such areas  could cause an explosion or fire resulting in injury or even death. NOTE: Areas with potentially  explosive atmospheres are often, but not always clearly marked. They include fueling areas such as  below deck on boats; fuel or chemical transfer or storage facilities; areas where the air contains ...
  • Page 4   Exposure to Radio Frequency Energy    Your CRYSTAL two‐way radio complies with Australian Communications Authority Radio  communications (Electromagnetic Radiation‐Human Exposure) Standard, 2003. To assure optimal  radio performance and make sure human exposure to radio frequency electromagnetic energy is  within the guidelines set out in the above standards always adhere to the following procedures.   ...
  • Page 5 Transmit and Receive Procedure  Your two‐way radio contains a transmitter and a receiver. To control your exposure and ensure  compliance with the general population/uncontrolled environment exposure limits, always adhere  to the following procedure: • Transmit no more than 50% of the time.    • To receive calls, release the PTT button.    • To transmit (talk), press the Push to Talk (PTT) button.  Transmitting 50% of the time, or less, is important because the radio generates measurable RF  energy exposure only when transmitting (in terms of measuring standards compliance). Always  hold the radio approximately 5cm in front of your mouth with the antenna pointing away from  your head.    Radio Operation and EME Exposure    Unauthorized antennas, modifications, or attachments could damage the radio and violate  compliance. Do NOT hold the antenna when the radio is “IN USE.” Holding the antenna reduces the  effective range. Do not use the radio if the antenna is damaged. If a damaged antenna makes  contact with your skin, a minor burn can result. If you wear a radio on your body when  transmitting, always fit the radio on the belt clip (supplied). Always ensure the radio and it's  antenna are at least 5cm from your body when transmitting.      Electromagnetic Interference/Compatibility  Nearly every electronic device is susceptible to electromagnetic interference (EMI). To avoid the  possibility of electromagnetic interference and/or compatibility conflicts, turn off your radio in any  location where posted notices instruct you to do so such as health care facilities.      Aircraft  When instructed to do so, turn off your radio when onboard an aircraft. Any use of a radio must be  in accordance with applicable regulations per airline crew instructions.    Medical Devices – Pacemakers  The Advanced Medical Technology Association recommends that a minimum separation of 6  inches (15cm) be maintained between a handheld wireless radio and a pacemaker. These  recommendations are consistent with the independent research by and recommendations of the  U.S. Food and Drug Administration. People with pacemakers should: • ALWAYS keep the radio  more than 15cm from their pacemaker when the radio is turned ON. • Not carry the radio in the  breast pocket.    • Use the ear opposite the pacemaker to minimise the potential for interference. • Turn the radio ...
  • Page 6: Installation

    young children.        INSTALLATION    Removing the belt clip  Belt clip   Pull the belt clip latch away from the unit.                                    Installing the Batteries    Slide down the battery compartment cover.    Insert 4 x AAA batteries (not supplied).    Position the batteries according to the    polarity marking on the battery compartment.    After placing batteries into correct positions,  replace the battery cover.    DBH09R ...
  • Page 7 Low Battery Meter Indicator  The radio can detect the low battery level when the battery voltage goes low. The battery icon will  display the low battery status  When battery voltage is low, the empty battery symbol will appear and continue to blink. The  battery symbol will continuously blink until it totally drains the battery voltage where then you will  have to replace the batteries.      Transmitting Range  The talk range will depend on your surroundings and environment it will be affected by  obstructions such as hills or buildings.    Don’t try to use two radio units which are less than 1.5m (5 feet) apart. Otherwise, you may  experience interference. Talk range depends on the terrain. It will be affected by concrete  structures, heavy foliage and by operating radios indoors or in vehicles.     ...
  • Page 8                                                            ...
  • Page 9 Operating the unit  Turning unit on/off:    1‐ Switching on  Press and hold the MENU/PWR until you hear a beep sound.        2‐ Switching off  Press and hold the MENU/PWR until you hear a beep sound.      Adjusting the Volume:    You have 8 preset volume levels. They are displayed on the LCD screen. To raise the volume press  the up button and to decrease the volume, press the down button.    Lock & Unlock the device.   Press and hold CALL button for 3 seconds to lock the device.  Press and hold CALL button for 3 seconds to unlock the device.    Auto scan.  Press & hold the MONI button for 3 seconds to activate auto scan.  Press & hold the MONI button for 3 seconds to deactivate auto scan.    Changing Channels:  You have a maximum of 80 channels at your disposal. To communicate with another device, you  must both be on the same channel.  To change channels, once you have turned your unit on, you need to press the MENU/PWR once  and use the up/down buttons to scroll through to your desired channel. To set your desired  channel, press the MONI button or wait up to 10 seconds.    Your unit is simplex “one way at a time”. While you are speaking, you can not receive a  transmission.  Your unit is an open‐license band. Always identify yourself when transmitting on the same channel.    IMPORTANT: Before transmitting on a UHF channel listen to ensure it is not already in use.    Transmitting (sending speech)  The unit is continuously in the Receive mode when the unit is turned ON and not transmitting.  When a signal is received on the current channel, “RX” icon will be displayed on the LCD screen. a. ...
  • Page 10   Roger Beep  This is a tone which is automatically transmitted whenever the PTT button is released. This alerts  the receiving party that you have ended the transmission, and you are now in receive mode. ...
  • Page 11   Channel 5 and 35 (paired for Duplex repeaters) are reserved as emergency channels and should be  used only in an emergency. CTCSS and DCS will not operate on channels 5 and 35.    A list of currently authorised channels can be obtained from the ACMA website in Australia and the  MED website in New Zealand. Channel 11 is a calling channel generally used to call others and  channel 40 is the customary road vehicle channel.    Once contact is established on the calling channel, both stations should move to another unused  “SIMPLEX” channel to allow others to use the calling channel. ...
  • Page 12: Uhf Channels And Frequencies

    Channels 22 and 23 are for Telemetry and Telecommand use, voice communications are  not allowed on these channels by law. Channel 9 and above are the best choices for general  use in Simplex mode.    Radiocommunications (Citizen Band Radio Stations)    Class Licence 2002  No licence is required to own or operate this radio in Australia and New Zealand. The  Radiocommunications (Citizen Band Radio Stations) Class Licence 2002 contains the technical  parameters, operating requirements, conditions of licence and relevant standards for Citizen Band  (CB) radios. CB radios must comply with the class licence for their use to be authorised under the  class licence.      UHF channels and frequencies  IMPORTANT NOTE: The operation of your UHF radio in Australia and New Zealand is subject to  conditions in the following licenses: In Australia the ACMA Radio communications (Citizen Band  Radio Stations) and in New Zealand by MED the General User Radio License for Citizen Band Radio.     ...

This manual is also suitable for:

Dbh20Dbh09rDbh10rDbh20r