Advertisement
REMOVING THE CLEANER FROM THE POOL
• Slowly pull the blue cord to get the cleaner to the pool surface and near
the edge of the pool. DO NOT PULL THE CLEANER OUT OF THE POOL BY
THE CORD.
• Reach down and grasp the handle of the cleaner and remove it from the
pool as shown below.
FIGURE 1: Grasping Handle
• Clean filter bag.
• Store the cleaner on the optional
caddy, if available.
• Loosely coil the cable for storage.
CLEANING THE FILTER BAG (Filter Bag Should Be Cleaned After Every Use.)
• Turn cleaner upside down and place on ground so the bottom lid is exposed.
• Turn red locking pegs (by wheel area) to the unlocked position as shown in Fig 3. Next
press the two red locking clips near the roller brush in
towards the center of the unit. Lift the bottom lid out.
B
A: Press the red tabs inward as shown
and lift lid off cleaner
B: Turn levers inward as indicated by
arrows imprinted on lid
www.smartpool.com
FIGURE 2: Lift from Pool by Handle
The unit should be stored in an area that
will afford some protection from the
elements to insure that it retains its finish.
A
FIGURE 3
• Hold the bottom lid as shown in Fig 4 and pull the tab marked "PULL TO REMOVE BAG"
• Turn filter bag inside out and hose off all debris as shown in Fig 5. If very dirty it may
be washed in your washing machine, inside out, with cold water, mild detergent, and
by itself.
• Hose all debris off the bottom lid being sure to get all dirt out of the fine filters on the
intake doors as shown in Fig 6.
4
FIGURE 4
FIGURE 5
FIGURE 6
Advertisement
