Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Advertisement
Table of Contents
Related Manuals for Movies 2 go MM1504
Summary of Contents for Movies 2 go MM1504
-
Page 1: Installation Guide
MM1504 15.4" ROOF-MOUNTED TFT-LCD VIDEO MONITOR Installation Guide... -
Page 2: Important Notice
Important Notice An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in “park”... -
Page 3: Materials Included In This Package
MATERIALS INCLUDED IN THIS PACKAGE: MM1504 TFT-LCD Monitor (P/N 136-4466) (1 pc) Power Cable (P/N112-3845) (1 pc) Remote Control (P/N 136-4457) (1pc) Hardware Package: • M4.2 x 16mm Phillips Self Tapping ST Pan Head Washer Screws (10 pcs) • M4 x 8mm Phillips ST Pan Head Screws (8 pcs) - Page 4 GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, RF Modu- lator/external amp, remote headphones, DVD, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups. 3) Decide upon mounting locations of all components and method of mounting. 4) Prep the vehicle by removing any interior trim necessary to gain access to vehicle's wiring as well as all areas where interconnecting wire harnesses will need to be located.
-
Page 5: Vehicle Preparation
VEHICLE PREPARATION: 1) Locate a Battery and accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off). Also find a location that will provide a good grounding point. Generally, this wire can be found at the ignition switch or fuse-box. -
Page 6: Trim Ring Installation
(or bend) when the mounting screws are tightened. The trim ring MUST be screwed to the unit. (Refer figure 1.) Figure 2 Figure 1 2) The MM1504 is now ready to be mounted in the vehicle. (Refer figure 2.) Figure 3 Figure 2... - Page 7 MOUNTING THE TRIM RING Roof Roof Support Headliner Mounting Bracket (4) Self-Tapping Screws (not supplied) Trim Ring Video Unit (5) # 8 Flat Washers 8 CM 4x8 Screws (5) # 8x3/4? Self-Tapping Screws...
- Page 8 Fuse all power leads at the vehicle's power source.
- Page 9 MM1504 MONITOR WIRING 1. AUX A/V, Output An auxiliary A/V output is provided to drive an external monitor. 2. AUX 1/AUX 2 A/V Inputs RCA Jacks: Can be connected to an external source. 3. Battery + Lead (Yellow)* Connect to the positive terminal of the car battery.
-
Page 10: Monitor Installation
Monitor Installation To install the monitor: 1. Disconnect the negative terminal of the battery. 2. Disconnect the original dome light. 3. Attach the metal mounting plate to the roof bow using the 10 ST 4.2 16mm screws and washers. Use care to avoid damaging the vehicle roof. 4. -
Page 11: Troubleshooting
TROUBLESHOOTING SYMPTOM: REMEDY: No power at Video Monitor -Verify +12 VDC on Red wire at Yellow wire Power Harness be hind video monitor. Verify ground con- nection with continuity test from known good ground to black wire at Power Harness Power but no video or sound -Verify that the correct source is selected (DVD, AV 1 or AV 2). - Page 12 © Copyright 2007 AEC 150 Marcus Blvd. Hauppauge, NY 11788 128-8154...