Table of Contents
Advertisement
Stopping the Trimmer
To stop the trimmer, release the trigger (Figure 8).
Removing the Battery
To remove the battery from the trimmer, grip the handle, press
down on the latch, and pull the battery out of the cavity.
1. Handle
2. Battery housing
Note: Do not grip the housing around the battery. Tthis will make
it more difficult to remove the battery from the trimmer.
Note: If you have trouble removing the battery, apply some
dielectric grease to the battery terminals (Figure 11). Do not
use any other type of lubricant as it can cause damage to the
terminals.
1. Battery terminals
Figure 10
3. Latch
Figure 11
Charging the Battery Pack
Important: For best results, your battery tool should be
charged in a location where the temperature is more than 5°
C (41° F) but less than 40° C (104° F). To reduce the risk of
serious personal injury, do not store outside or in vehicles.
Charging time will be increased if not charged within this
range.
1. If the power cord is not plugged in to the charger, plug it in
to the charger (Figure 12), then plug the power cord into
a power socket.
2. Turn the battery upside down and line up the battery terminal
with the slot in the charger (Figure 12 and Figure 13).
1. Insert battery here
2. LED indicators
1. LED indicators (level of
charge)
2. Release button
3. Slide the battery into the charger until it clicks into place.
4. Hold down the charger, pull up on the release button, and
slide the battery backward out of the charger.
9
Figure 12
3. Charge/storage mode
switch
4. Power cord plug-in
location
Figure 13
3. Battery terminal
4. Test button
Advertisement
Table of Contents
