Screw In And Out Of Modeling Bulb - WalimeXPro VC-200 Instuction Manual

1. Mounting of reflector:
Switch off device.
See Switch the device on and off.
Cool down the device.
WARNING! Danger of burning on reflector, modeling lamp and flash
tube. Please cool down approx. 30 minutes.
Demount protection cap.
See Demount and mount protection cap.
Push back unlocking lever and keep pressed.
Plug the reflector into the openings, so that the opening for the umbrella
(optional) faces downwards.
Turn reflector clockwise and listen for the reflector to snap into place.
Release the unlocking lever.
Stick the safety cap onto the unlocking lever.
2. Demount reflector:
WARNING! Danger of burning on reflector, modeling lamp and flash tube.
Please cool down approx. 30 minutes.
Remove safety cap from unlocking lever.
Push back unlocking lever and keep pressed.
Turn reflector anticlockwise as far as it will go and take off from the
device.
Mount protection cap.
See Demount and mount protection cap.
7.

Screw in and out of modeling bulb

WARNING
Posterior danger of bursting of flash tube
Make sure not to touch the flash tube with bare hands accidentally.
11
B
A
1. Switch off device.
See Switch on and off of device.
2. Plug off power cord.
3. Cool down device.
WARNING! Danger of burning on reflector, modeling lamp and flash tube.
Please cool down approx. 30 minutes.
4. Screw in modeling bulb:
When the protection cap is mounted:
Demount protection cap.
See Demount and mount protection cap.
Screw the modeling lamp carefully into the socket.
5. Screw out the modeling bulb:
Screw the modeling bulb carefully out of the socket.
Demount protection cap.
See Demount and mount protection cap.
A Socket
B Modeling lamp
12