Change Flash Tube - WalimeXPro VC-200 Instuction Manual

Part of the device
Housing
Modeling bulb, flash
tube
Reflector

17.3. Change flash tube

WARNING
Please just use flash tubes, which are conform with the required
specifications as to avoid the bursting of the flash tube. See Technical
Specifications.
WARNING
Posterior danger of bursting of flash tube
Don´t touch the flash tube with bare hands. Wear clean cotton gloves or use a
clean cloth.
Cleaning
Use a microfiber cloth to remove light and
stubborn dirt.
Wipe off with dust brush or dry, soft cloth
ADVICE:
Don´t clean the modeling bulb and flash tube
with water. Even small residues on the bulbs
could lead to bursting
Remove dirt with microfiber cloth
25
B
C
A
1. Discharge device:
WARNING! Danger of electric shock. Discharge the device before
changing the flash tube.
Switch on device.
See Switching on and off of the device.
Trigger flash:
Press push-button TEST and switch off main switch immediately.
ADVICE: If you don´t switch off the main switch within 0.5 s, the device
will charge anew.
Unplug power cord.
2. Cool down device.
WARNING! Danger of burning on reflector, modeling lamp and flash
tube. Please cool down approx. 30 minutes.
3. Remove old flash tube:
Demount reflector.
See Demounting and mounting of reflector.
Screw out modeling lamp.
See Screw in and out of modeling lamp.
Hook off the retention clip with pliers.
A Flash tube
B Retention clip
C Socket for modeling lamp
26