Boat Battery Pack Installation; Charging Warnings - Himoto Stealth Enforcer ST760 Instruction Manual

Radio controlled electric power boat
Table of Contents

Advertisement

Stealth Enforcer
Length
581mm
Beam
177.5mm
Transmitter
2.4GHz Radio
Control TX

Boat Battery Pack Installation

1. Lift the back of the canopy lid off the magnet
and pull it back and away from the hull to remove.
2. Adhere loop tape (included) to the battery.
Do not cover the battery warning label.
3. Connect the battery.
4. Secure the boat battery on the hook strip in the boat.
5. Refer to Getting Started instructions about powering
on your boat.

Charging Warnings

WARNING:
Never leave a charging battery pack unattended. Monitor the battery periodically for heat
and if at any point the temperature exceeds 120F, disconnect from the allow it to cool
fully before reconnecting.
Motor :
Watercool RC560 Motor(ST760)
Watercool Brushless Motor(ST760BL)
Speed Control :
2in1 Waterproof ESC / Receiver(ST760)
Waterproof Brushless ESC(ST760BL)
Battery :
10.8V 1100mAh NiMH Battery(ST760)
Li-Po Battery(ST760BL)
08
Propeller :
Hull Material :
3
2
40x32mm
ABS+PC
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stealth enforcer st760bl

Table of Contents