BC Acoustique EX502 Owner's Manuel

Power amplifier

Advertisement

Quick Links

Power Amplifier

OWNER'S MANUEL
MODE D'EMPLOI
MANUEL DEL USUARIO
BEDIENUNGSANLEITUNG
BC ACOUSTIQUE
BP 306 - 94709 Maisons-Alfort Cedex France

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EX502 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BC Acoustique EX502

  • Page 1: Power Amplifier

    Power Amplifier OWNER’S MANUEL MODE D’EMPLOI MANUEL DEL USUARIO BEDIENUNGSANLEITUNG BC ACOUSTIQUE BP 306 - 94709 Maisons-Alfort Cedex France...
  • Page 2: Table Of Contents

    Introduction Dear Customer, Thank you for choosing a BC Acoustique product. Its implementation has been our know-how, both in terms of design to the manufacturing. Electronic components and mechanical parts correspond to the selection criteria of very high quality. Operation and finish of each product have been checked before delivery. To obtain best results, please read the advice contained in this document.
  • Page 3: Recycling Product

    BC Acoustique or not BC Acoustics dealer or technician area. approved, authorized to carry out maintenance and repair under warranty for BC Acoustique.
  • Page 4: Basic Instructions: Quick Start

    Connect the speakers to dedicated speakers plugs to the Important Notes: rear of the Power Amplifier, and the pre-amplifier to the The EX502 has 2 pairs of speaker’s terminals for easier corresponding input jacks (RCA) on the rear panel. connection of two pairs of speaker. We recommend you check the impedance of your speakers.
  • Page 5: Front Panel - Connections And Use The Amplifier

    However sometimes this connection "mass" is the origin of "hum" audible from the speakers in a hi-fi If the "AUTO" mode is selected, then the EX502 will go into system to solve this problem, the cancellation of the ground standby mode if there is no input signal for an extended connection is sometimes sufficient.
  • Page 6: Specifications

    ③ ④ manufacturers have long been used to practice low In the case of operation of the EX502 in "MONO" mode, impedances (watch for the amp, even if the average only the gain control "right" is effective. impedance is reasonable, local impedance drop will induce a strong current demand).
  • Page 7: Troubleshooting

    For repair, during or after the warranty, please contact your dealer. To obtain warranty service and technical support, thank you kindly to register your product online on the website www.bc-acoustique.com at the product registration section. BC ACOUSTIQUE BP 306 94709 Maisons-Alfort Cedex France www.bc-acoustique.com...
  • Page 8 BC ACOUSTIQUE BP 306 94709 Maisons-Alfort Cedex France www.bc-acoustique.com...

Table of Contents