What To Do If - Bosch WAE18060AU Instruction Manual

What to do if ...

Water is leaking out. – Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply. – Start/Pause
Detergent not dispensed. – Tap not turned on?
– Filter blocked? Clean the filter –> page 10.
– Supply hose kinked or trapped?
Washing machine door – Safety function active. Wait approx. 2 minutes.
cannot be opened.
Programme does not – Start/Pause
start.
– Washing machine door closed?
Detergent solution is not – Clean the detergent solution pump –> page 10.
drained.
– Clean the waste pipe and/or drainage hose.
Water not visible in the – Not a fault - water below the visible area.
drum.
Spin result not – Distribute large and small items of laundry evenly in the drum.
satisfactory.
Spin cycle performed – Not a fault - unbalanced load detection system adjusts the
several times. imbalance.
Residual water in the – Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary –> page 9.
products.
Odour formation in the – Run programme Cotton
washing machine. standard detergent.
Foam escaping from the – Too much detergent used?
detergent drawer. If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation, – Are the appliance feet fixed?
vibrations and Secure the appliance feet –> Installation instructions.
"wandering" during the
– Transportation safety devices removed?
spin cycle.
Remove the transportation safety devices –> Installation
instructions.
Display panel/indicator – Power cut?
lamps do not function
– Fuses triggered? Reset/change the fuses.
during operation.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence – Not a fault - unbalanced load detection system adjusts
longer than usual. imbalance by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues on – Occasionally, phosphate-free detergents contain water-insoluble
the laundry. residues.
– Select Rinse
If you cannot correct a fault yourself or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service –> Installation instructions.
not selected?
selected?
90 °C without laundry. Use
or brush the laundry after washing.
Observe the safety instructions on page 8.
Read these instructions and the separate installation instructions
before operating the washing machine.
11
Washing machine
Instruction manual en