Operating Your Radio - Fm Auto-Tune - Sangean DDR-33+ User Manual

Operating your radio - FM auto-tune

1. Fully extend the telescopic aerial located on the rear of your radio.
Place the telescopic antenna so a that it is as straight as possible
extending vertically either above or below the radio.
2. Press the On / Standby button to switch on your radio.
3. Press the Mode button to select the FM band.
4. Press and hold down Tuning Up button to increase the frequency
you want, once you release Tuning Up button, the frequency will stop
automatically when it finds a station of sufficient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
6. To find other stations press and hold down the Tuning Up button,
and release Tuning Up button as before.
7. Press and hold down the Tuning Down button to decrease the
frequency you want, once you release Tuning Down button,
the frequency will stop automatically when it finds a station of
sufficient strength.
8. When the end of the waveband is reached your radio will
recommence tuning from the opposite end of the waveband.
9. Adjust the Volume to the required setting.
10. To switch off your radio press the On / Standby button.
15