Stealth bomber Owner's Manual page 16

WARNING: Only use the charger specified by Stealth Electric Bikes. Failure to do so may result in serious injury or
Stealth battery packs have no memory effect. This means that they can be recharged or discharged from any state of
charge. Wherever possible keep your battery fully charged.
CAUTION:
The battery charger for your Stealth Bike can operate on dual voltages (120V/240V). Before charging the bike for the first
time, make sure that the red switch on the back of the charger is set to the correct mains power supply voltage for your
region.
i. Ensure the bike is switched off and the charge port is clean and dry.
ii. Connect the charger to the wall socket. A red and a green light should illuminate.
iii. Now connect the charge plug to the charge socket located on the front LHS of the bike. The charger should then
display 2 red lights, and the charge cycle should commence.
iv.
The complete charge period should last approximately 2-2.5 hours. At the end of the charge cycle the charger will
illuminate 1 red and 1 green light. This indicates that the battery is fully charged and the charger can be
disconnected.
Ensure bike is turned off
damage to property.
Ensure charge port is clean
and dry
Two red lights are displayed
when battery is charging.
You should also be able to
hear the fan running
STEALTH ELECTRIC BIKES 2013 OWNER'S MANUAL
Connect charger to charge
port
A red and green light is
displayed when charger is
disconnected from bike or
battery is fully charged
V 1.2 PAGE | 16