Install The Seat Post - Stealth bomber Owner's Manual

White Brothers
If your bike is equipped with White Brothers forks see White Brothers manual for wheel installation.
3. Install the pedals
WARNING: When installing the cranks and pedals to the bike please take note that the pedals and cranks are labelled
"L" and "R" and must be installed accordingly. Failure to do so can result in serious injury and damage to the bike.
Bomber:
Pedals come pre-fitted to the cranks at delivery. The pedal/crank assemblies can be installed using an 8mm Allen key.
I. Ensure pedal is securely fastened to the crank.
II. Connect pedal/crank assembly to gearbox.
Fighter:
Cranks come pre-fitted to bike. The pedals can be fitted using a 15mm pedal spanner.
I. Unwrap pedals and separate left from right, represented as a L and R respectively on the end of the thread.
II. Tighten on to respective cranks using pedal spanner.

4. Install the seat post

The supplied seat posts are extra-long and suitable for taller riders. Shorter riders may find that they need to cut the length
of the seat post to avoid contact with the rear shock. Avoid contact between the shock spring and the seat post and make
sure that the shock will not contact the seat post when the suspension is fully compressed.
I. Bolt the seat to the post loosely.
II. Slide the seat post into the seat tube and adjust the height accordingly.
III. Adjust the tilt of the seat back and forth using the adjusters located on the seat post.
IV. Tighten all bolts. Ensure that there is always a minimum of 50mm of overlap between the seat post and the seat
tube (frame).
STEALTH ELECTRIC BIKES 2013 OWNER'S MANUAL
V 1.2 PAGE | 14