Getting Started; Using Your Remote Control With A Vcr And Dvd - Sharp 25R-S100 Operation Manual

Getting Started
TV Installation
Before turning on the television set:
1. Place the batteries into the remote control.
2. Connect the antenna cable into the television.
3. Plug the AC Power cord into the wall outlet.
4. Press the POWER button on the TV or the Remote Control to turn on the TV. The SELECT LAN‐
GUAGE screen will come up.
5. Press CH UP ( ) or DOWN ( ) to select "ENGLISH", "ESPAÑOL (SPANISH)" or " (FRANÇAIS)
FRENCH".
6. Press VOL (+) or (–) to start the EZ SETUP option.
7. Press VOL (+) and the tuner will start to search for the broadcasting and cable TV channels. The
CH No. will automatically start to increase when it first appears. The first time you start the TV, it
will automatically memorize the broadcasting channels. To stop the EZ SETUP process once it
starts, press VOL (–) to cancel it .
(To SETUP again, please refer to page 8 on SET UP. )
8. Once EZ SETUP is complete, the lowest channel number memorized will be displayed.
Using your Remote Control With a VCR and DVD
Your Remote Control has been set at the factory to operate your TV and many remote
control VCRs, Cable TV converters, and DVD players. However, in some cases an easy one‐time
set‐up step may be necessary before the remote will operate accessory VCRs, cable TV
converters and DVD players.
• In this set‐up step, the remote locates and memorizes the remote control transmitter code
for the VCR, Cable TV converters and DVDs.
• Once "identified", the remote sends the proper remote signals to operate your accessory.
• Once the remote has "identified" the VCR or DVD player, your remote control is fully functional
and ready to operate.
• For detailed information on the use of the VCR or DVDs, refer to the operation manual of the
VCR or DVD players.
NOTE: Depending on the model year produced, brand, and type of VCR, Cable TV converter, and
DVD, some models may not be compatible with the remote control. Also, some brands of the
Cable TV converter Box may not enable channel selection until the ENTER is pressed.
6