Life Fitness 97Ti Service Manual page 129

Life Fitness Model 97Ti, 95Ti, 93T, 97Te, and 95Te Treadmills
How To... Replace the Rear Roller Guards
Special Service Tools Required: NONE
NOTE: The following steps are applicable to units with Configuration No. 2, Rear Roller Guards.
1. Remove existing Roller Guard by unscrewing mounting screws on top and base of frame.
2. With flat blade screwdriver, remove Grommet and Washer, discard old washer and re-install the
grommet. Use caution to prevent injury or damage to paint.
NOTE: Do not replace washer. Having a washer and the grommet will raise the guard too high
and cause rubbing against the belt resulting in premature wear and reducing belt life.
3. Remove the Base's Low Profile Grommet for the base bottom hole and move it to the upper hole in
the Base Frame.
Mounting
Screws
23