GE GCW200YAWC Use & Care Manual page 24

3. Remove any substances in the filter.
1) Open the main tap water valve and check if water comes out of the
Water Tube.
2) Check if the Water Valve is open in case water does not come out.
3) Leave the valve open until clean water is coming out.
❈ Initial water may contain some substances out of filter (manufacturing
process).
4. Attach the Filter Box
1) Screw and fasten the filter holder to the left/right side of the back of
refrigerator.
❈ In case the holder is not fastened well, remove the back paper of
the tape on the filter holder and attach it."
2) Insert the filter box into the holder.
5. Connect the Water Tube to the refrigerator.
1) Remove the rear cover at the bottom back of the refrigerator.
2) Insert the fastening ring into the Water tube.
(Be careful to follow the direction of the nut.)
3) Insert the Water Tube into the top of the Water Valve, turn the nut
clockwise to fasten it. (The Water valve is to the right of the motors.)
4) Check for any bent tubes or water leaks; if so, re-ckeck instalation
procedure.
5) Replace the rear cover. (The Water Tube should be placed between
the groove of the refrigerator back and motor cover.)
N.B. Set the tube upright as the figure shows.
6. Fasten the Water Tube.
1) Fasten the Water Tube with the [Fastener A] .
2) Check if the tube is bent or sqeezed. If so, set it right to prevent any
water leak.
7. After installation of Water Supply System
1) Plug in the refrigerator, press the [WATER] button on the control panel
for 2~3 minutes to remove any air (bubble) in the pipes and drain out
the initial water.
2) Check for the water leaks again through the water supply system
(tubes, connectors and pipes) Rearrange the tubes again and do not
move the refrigerator.
Installation Preparation
Water
Tube
Connector
Ref Side
Water
Water Tube
Water Tube
Water Tube
Water Valve
Fastener A
Water Tube
Tap
Connector
Water Tube
Tap
Nut
23