Table of Contents
Advertisement
Charging
Your scooter comes charged out of the carton. We still recommend charging
the unit for 6-8 hours prior to it's first use. We also recommend charging your
scooter after each use and prior to storage.
Master Power/Kill Switch
Located on the dash, near the ignition is a master power/kill switch. This
switch must be on to operate the scooter and on during charging. This switch
will cut all power to the motor.
WARNING: Do not allow your scooter to go into deep discharge, as this will
damage the batteries.
Fig. 4
Fig. 5
Riding
1. Make sure that all of the exposed bolts and screws are tightened.
2. Raise the kickstand to its upright position.
3. Turn the master power/kill switch to the ON position.
4. Turn the Ignition key to the on position.
Gently rotate the THROTTLE GRIP, on the right side of the handlebars.
5.
The EW-700 will begin to move on its own power. Your scooter has a
variable speed hand throttle. You can control the speed of your scooter by
the amount of pressure you use when rotating the hand throttle. The more
you rotate, the faster you will go.
1. Locate the master kill switch next to
the ignition on the dash. Turn to
the on position. Note the master
kill switch must be in the on
position for the scooter to accept
a charge.
2. Open the charging socket cover
located on the left side of the
scooter body. (Fig. 4)
3. Locate your Battery Charger. (Fig.
5)
Find the charger socket end
that has a three-prong socket and
plug it into the scooter.
4. Next, plug the AC plug into a wall
outlet.
When first plugged in, the charger has two
red lights that will illuminate at the same
time, indicating that the charging process
has started. Once the light on the charger
turns green, you may remove the charger
and close the safety cap.
Page8
Advertisement
Table of Contents
