Advertisement
Technical specifications Pro-Ject Phono Box S
A
Typical for low output MC cartridges,
* Input capacitance is irrelevant for low-output MC cartridges
Input impedance:
Input capacitance / impedance:
Input gain:
Noise floor:
THD:
RIAA-equalisation curve accuracy:
Subsonic filter:
Input:
Line-level output:
Outboard power supply:
Power consumption:
Dimensions W x H x D (D with sockets): 103 x 36 x 104 (115)mm
Weight:
Potential incorrect use and fault conditions
No signal on one or both channels:
No connection between player and phono amplifier or amplifier. This could be due to a faulty plug,
broken wire or solder joint or simply loose plug/socket connection.
Strong hum:
No earth connection from cartridge or arm, or arm cable to phono amplifier, or earth loop.
Output too quiet or too loud, or distorted:
Input gain incorrectly set - input overloading or insufficiently amplified.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
©
2012. All rights reserved.
B
typical for MM or high output MC cartridges
10ohms, 100ohms, 1kohm
100pF, 200pF, 320pF and 420pF */47kohms
Together with other input impedance settings without any influence!
40 and 43dB
B
/ 60 and 63dB
94dB (A weighted) at 40dB and 43dB input gain
75dB (A weighted)at 60dB and 63dB input gain
<0,01% at 40dB and 43dB input gain
<0,05% at 60dB and 63dB input gain
20Hz - 20kHz / max. 0,4dB
at 20Hz with 12dB/octave
1 pair RCA/phono sockets
1 pair RCA/phono sockets
18V/500mA DC, suitable for your country's mains supply
85mA DC, <1W in standby
570g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
© Audio Trade GmbH · Pro-Ject Phono Box S · Revision 2013.1.15
A
B
A
5
Advertisement
