Related Manuals for Remock Lockey Next Generation Wireless Door Lock with Remote Control
Summary of Contents for Remock Lockey Next Generation Wireless Door Lock with Remote Control
- Page 1 Next Generation Wireless Door Lock with Remote Control User Instruction Manual Please read carefully the following instruction for your safety before using the product. It is important to understand how this lock works to use it correctly...
- Page 2 Warning Elements When the LED light is flickering and beep signals sound different from usual, please change batteries immediately.( refer to page6) Please make sure that you don't drop it or get it wet because it's a highly sophisticate product made from semiconductors.
- Page 3 Next Generation Wireless Door Lock with Remote Control User Instruction Manual Please read carefully the following instruction for your safety before using the product. It is important to understand how this lock works to use it correctly...
-
Page 4: User Instruction
User instruction Open the battery cover by pushing it to the direction (▼)and then insert two AA alkaline batteries (refer to page 6) Close the battery cover. Please remember! Once the lock is installed, please ensure that the remote control works properly by testing it outside the door. -
Page 5: Name Of Each Part
Composition and name of parts Photos of the following components are presented to increase your understanding and may be different from actual products. Components Body Base Steel Plate Latch &Assistant Busing AA Alkaline Battery Remote Control NAME OF EACH PART. rubber packing latch with rear plate... - Page 6 Change of batteries for the lock body Lock Body The LED light flickers every 4 seconds to signal the need for battery replacement. In addition, when signals sound different from usual, you are also required to change batteries as follows: Locking and opening signals * Push lock button→...
- Page 7 Replacement of Remote Control Battery Please replace the battery of remote control when the LED light becomes dimmer and the operation speed slows down. Replace battery Insert the tip of Assemble sequence: Use a (-) Test driver into a (CR 2032) front case→rubber shaped small main body and...
- Page 8 How to register or delete the code of between remote controls and lock body Check if LED light flickers 1 Open the battery cover. 2 There is registration button in the middle of the left side of battery holder. 3 Press registration button with a stick-like tool for about 2 seconds. 4 The LED light flickers with a sound of "Pi-ri-lik"...
- Page 9 Establishment common sense Please test the four remote controls from out side with leaving the key body inside before installation. Check the door condition (material, shape and surface) If the door has an unsmooth surface or its paint peels and if it is a wood door, we cannot guarantee your security after installation.
- Page 10 How to install and disassemble 1. Take off the adhesive tape from latch. 2. Push and attach latch to door pillar. At this stage there is no need to detach adhesive tape from the body. 3. Now please detach adhesive tape from the body. 4.
-
Page 11: Specification
Specification ▶ ASK SINGLE CONVERSION ▶ 315MHz (±500KHz) ▶ Alkaline AAM size 2 pcs ▶ 6 months based on 20 times per day ▶ -20℃ ~ 60℃ (in no freezing and dew condition) ▶ 5%~80%(in no dew condition) ▶ Number of registered remote controller: 16 different codes can be registered respectively. -
Page 12: Warranty
Warranty 1. We offer after-service for free when the product is broken during the warranty period after it was installed in compliance with the user instruction manual. You can bring the product to the dealer or us. 2. However we charge fee for the following services even during the warranty period: Even in the guarantee period, charged repair will be made in the following cases: a) When there is no evidence on the date of purchase b) When failure or damage was caused by natural disaster such as fire, earth quake, water...
Need help?
Do you have a question about the Next Generation Wireless Door Lock with Remote Control and is the answer not in the manual?
Questions and answers