Subscribe to Our Youtube Channel
Related Manuals for Sunrise Solartech PV Modules
Summary of Contents for Sunrise Solartech PV Modules
-
Page 1: Table Of Contents
Installation Guide of Sunrise Solartech PV Modules Term 2011 Contents Purpose of this guide General Safety precaution for installing a solar Photovoltaic system Product Identification Mechanical Installation Selecting the location Selecting the proper support frame Ground mount Roof mount Pole mount... -
Page 2: Purpose Of This Guide
Purpose of this guide This guide contains information regarding the installation and safe handling of Sunrise Solartech Co., Ltd photovoltaic module (hereafter is referred to as “module”). Sunrise Solartech Co., Ltd hereafter is referred to as “Sunrise”. Installers must read and understand the guide before installation. Any questions, please contact our sales department for further explanations. -
Page 3: Safety Precaution For Installing A Solar
When installing the system, abide with all local, regional and national statutory regulations. Obtain a building permit where necessary. Safety precaution for installing a solar photovoltaic system Solar modules produce electrical energy when light shines on their front surface. The DC voltage may exceed 30V. -
Page 4: Mechanical Installation
This bar code is inserted at the beginning of laminating. Typical serial number barcode label Do not remove any label. If the label is removed, the product warranty will no longer be honored by Sunrise. Mechanical Installation Selecting the location Select a suitable location for installing the modules. -
Page 5: Ground Mount
Mechanical Installation The support module mounting structure must be made of durable, corrosion-resistant and UV-resistant material. Ground mount Select the height of the mounting system to prevent the lowest edge of the module from being covered by snow for a long time in winter in areas that experience heavy snowfalls. In addition, assure the lowest portion of the module is placed high enough so that it is not shaded by plants or trees or damaged by sand and stone driven by wind. -
Page 6: Pole Mount
install modules on a roof or building during strong winds in case of accidents. Mechanical Installation Pole mount When installing a module on a pole, choose a pole and module mounting structure that will withstand anticipated winds for the area. General installation Module mounting must use the pre-drilled mounting holes in the frame. -
Page 7: Electrical Installation
If the support frame is made of metal, the surface of the frame must be electroplated and have excellent conductivity. We recommend the lay-in lug (Cat. No. GBL4-DBT is recommended by Sunrise) when grounding. First strip 16mm insulating jacket from the end of the ground wire carefully to avoid nicking or cutting conductors, insert the wire to the feet of the lug (see the picture), and screw down the slotted screw. - Page 8 Installation Guide 2011 8/10 www.srsolartech.cn...
-
Page 9: General Installation
Electrical Installation General installation Do not use modules of different configurations in the same system. The max. number of module (N) = Vmax system / [Voc(at STC)]. Several modules are connected in series and then in parallel to form a PV array, especially for application with a high operation voltage. -
Page 10: Commission And Maintenance
No responsibility is assumed by Sunrise for any infringement of patents or other rights of third parties, which may result from use of the PV product. No license is granted by implication or otherwise under any patent or patent rights.
Need help?
Do you have a question about the Solartech PV Modules and is the answer not in the manual?
Questions and answers