Samsung LTN173KT02-T01 Service Manual page 28

2. STORAGE
We highly recommend to comply with the criteria in the table below.
ITEM
Storage Temperature
Storage Humidity
Storage life
Storage Condition
3. OPERATION
(a) Do not connect, disconnect the module in the " Power On" condition.
(b) Power supply should always be turned on/off by following item 6.3
" Power on/off sequence ".
(c) Module has high frequency circuits. Sufficient suppression to the electromagnetic
interference shall be done by system manufacturers. Grounding and shielding
methods may be important to minimize the interference.
(d) The standard limited warranty is only applicable when the module is used for general
notebook applications. If used for purposes other than as specified, SEC is not to be
held reliable for the defective operations. It is strongly recommended to contact SEC
to find out fitness for a particular purpose.
4. OTHERS
(a) Ultra-violet ray filter is necessary for outdoor operation.
(b) Avoid condensation of water. It may result in improper operation or disconnection
of electrode.
(c) Do not exceed the absolute maximum rating value. ( the supply voltage variation, input
voltage variation, variation in part contents and environmental temperature, so on)
Otherwise the module may be damaged.
(d) If the module displays the same pattern continuously for a long period of time, it can be
the situation when the image "sticks" to the screen.
(e) This module has its circuitry PCB's on the rear side and should be handled carefully in
order not to be stressed.
Samsung Secret
Doc.No. LTN173KT02-T01
Unit
(℃)
(%rH)
- The storage room should provide good ventilation and temperature
control.
- Products should not be placed on the floor, but on the Pallet away
from a wall.
- Prevent products from direct sunlight, moisture nor water; Be
cautious of a build up of condensation.
- Avoid other hazardous environment while storing goods.
- If products delivered or kept in conditions of over the storage
period of 3 months, the recommended temperature or humidity
range, we recommend you leave them at a temperature of 20℃
and a humidity of 50% for 24 hours.
Rev.No
Min.
5
35
12 months
04-A01-G-120208
Approval
Max.
40
75
Page
/ 31
28