Page 2
Combustion Air Damper important (See “Preventing Chimney Fires” on page 2) . Break-in requires the burning of 15 bags of pellets or continuous burn for two weeks. If during the initial break-in period you experience difficulty keeping the stove burning or there appears to be an excessive amount of burning pellets being evacuated from the burn grate, it may be necessary to close the damper some more.
Page 3
Required maintenance depends content. Every St. Croix Pellet stove model will largely upon the quality of pellet fuel burned and have the same system as shown in figure 5 below. the rate of burn. The amount of daily There is a 2-piece burnpot.
Page 4
Daily Maintenance 2. Remove ash buildup under the grate bottom daily or as frequently as needed. Clean the ashes out from 1. Check Grate Weldment and Shaker Plate (See under the burn pot by pulling the Ash Cleanout Rod figure 5) to determine if holes are plugged. Clean in and out several times (see Fig.
Page 5
ASH CLEAN-OUT COVER (LEFT SIDE SHOWN) REMOVE SHIPPING SCREW & DISCARD THE LOCATION OF THE THIRD CLEAN-OUT/ASH REMOVE DECORATIVE TRAP BEHIND THE ASH PAN IN A PRESCOTT EXL GRILL (LEFT SIDE SHOWN) Figure 7 Prescott Series Operations Manual Page 11...
Page 6
3. Clean burn grate holes at least weekly. Remove 4. Periodic cleaning of the exhaust system is the burn grate and use a small metal object to required. Under certain conditions creosote clean out plugged holes. ( See fig. 5 on page 9. ) buildup may occur rapidly.
Page 7
Yearly Maintenance Carefully vacuum around the fan motors. If electrical wires become disconnected call your Yearly maintenance is designed to assure safe dealer for service. operation, prolong the life of the stove and help preserve its aesthetic appeal. 2. The exhaust system should be thoroughly cleaned at least annually.
Need help?
Do you have a question about the Prescott EXL and is the answer not in the manual?
Questions and answers