Archos Blood Pressure Monitor User Manual page 11

EN
Tie the Cuff
1. Remove all accessories (watch, bracelet, etc.) from your wrist. If your physician has
diagnosed you with poor circulation in your wrist, use the other wrist.
2. Roll or push up your sleeve to expose the skin.
3. Apply the cuff to your wrist with your palm facing up.
4. Position the edge of the cuff about 1-1.5 cm.
5. Fasten the wrist cuff around your wrist, leaving no extra room
between the cuff and your skin. If the cuff is too loose, the measurement
will not be accurate.
Resting for 5 minutes before measuring.
Wait at least 3 minutes between measurements. This allows your blood circulation
to recover.
For a meaningful comparison, try to measure under similar conditions. For example,
take daily measurements at approximately the same time, on the same wrist, or as
directed by a physician.
Pair-up the Blood Pressure Monitor with Your Device
1. Turn on Bluetooth and the app. Make sure both are ON
when pair-up is proceeding.
2. When the monitor is OFF, press and hold the START button
for 2 seconds to start pair-up. The symbol and the symbol will be shown on the LCD
alternatively, indicating pair-up is proceeding.
If SUCCEED, symbol will be shown on the LCD.
11