Installation Tips; Typical Installation; Filtered Units - Lindsay VacuMaid Owner's Manual

Installation Tips

Mounting Bracket
All VacuMaid® central vacuum units have the same mounting bracket. It is at-
tached to the unit for shipping and then must be removed for installation to the
wall.
1 Remove the small
piece of metal on the
side of the mounting
bracket and discard.
2 To remove the
mounting bracket, tap
lightly with a mallet.
The mounting bracket
will slide down.
Utility Valve Installation
Airflow Direction
Low Voltage Terminals
Proper placement of protector plate
Make sure the Protector Plate is in place. This is necessary
Protector plate must be installed
for proper suction.
properly for the vacuum to work
Upon receiving your vacuum system, lift o the lid. The
protector plate should be located inside the can just
below the HEPA bag.
The protector plate is installed correctly when it lays at,
prong side down, directly under the HEPA bag. The warn-
ing label should be facing up. The plate provides a barrier
Protector Plate
5
3 Continue
to tap with a mallet
until the mounting
bracket is completely
removed.
4 Attach the removed
bracket to the wall
and slide the unit onto
the bracket.
Low Voltage Wire Connections
Strip the wire, press the Quick Clips to the
right and insert the wire
into
the holes.
(for paper bag models only)
between the HEPA bag and mesh screen. This
allows air to circulate preventing the motor from
overheating.
Do not to throw this part away.
www.lindsaymfg.com
Typical Installation Design of Paper Bag Units Typical Installation Design of Paper Bag Units
Hanger Bracket

Filtered Units

Suggested
Guidelines
48" from oor
to top hole of
can bracket
NOTE:
* Power unit must be
mounted at least 6
inches from sidewall,
oor & ceiling.
48"
Typical Installation Design of Inverted Bag Units
Hanger Bracket
Suggested
Guidelines
48"
48" from oor
to top hole of
can bracket
www.lindsaymfg.com 6