Serial Number Location; Tips On The Care Of Your Central Vacuum - Lindsay VacuMaid Owner's Manual

SERIAL NUMBER LOCATION FOR CENTRAL VACUUM SYSTEM
The serial number for your wall mounted central vacuum system can be found on the serial label.
This label will be found on the left or right side of the unit near the top and close to the wall.
Example Label
Yours may differ
Scan the QR code on your unit label with a
smartphone QR scanner app and it will take
you directly to the manual for your unit.
LINDSAY MANUFACTURING, INC. / P.O. BOX 1708 /
VACUMAID® is a registered trademarks of Lindsay Manufacturing, Inc.
21
- IMPORTANT -
PONCA CITY, OK 74602-1708 / 580-762-2457
www.lindsaymfg.com
TIPS ON THE CARE OF YOUR CENTRAL VACUUM SYSTEM
Your power unit is warranted against defective materials and workmanship but
not against misuse. There is a service charge for repairing or replacing damaged
or misused components of the system or for unnecessary service calls. Your built-
in system is a lifetime improvement for you and your family. Follow these simple
tips and you will enjoy it for many years:
1) DO NOT PLACE ANYTHING ON TOP OF THE POWER UNIT
To do so would cause the motor to overheat as it will impair the
Model
cooling air flow.
2) DO NOT OVERFILL YOUR DIRT CANISTER
Serial #
Allowing the dirt canister to fill up to the bottom of the plastic cone
will nullify the cyclonic separator system and could cause debris to be
drawn into the upper screen which may, in time, damage your power unit.
3) USE ONE INLET AT A TIME TO MAINTAIN PROPER AIR FLOW
Using more than one vacuum inlet at a time reduces the air flow to a
level below that which is required to effectively deep clean your carpets.
4) STORE YOUR HOSE AND TOOLS PROPERLY
When not in use, always hang up your hose and store the cleaning tools
and wands in a place where they will not be damaged.
5) HOLD THE INLET DOOR OPEN WHEN REMOVING THE HOSE
After removing the hose from the inlet, hold the inlet door open for a
few seconds to:
a) Make sure the unit has stopped.
b) Clear any residual dirt out of the vacuum tubing
6) DO NOT PICK UP ANY LIQUIDS
Do not pull liquids into the vacuum tubing since any liquid left in the
tubing may:
a) Drain back out of the wall inlet and cause streaking of the walls.
b) Cause dirt build-up in the tubing that could eventually clog the
system.
Wet Pick-up Units are available for this type of use.
7) BE CERTAIN TO REGISTER YOUR PRODUCT
Take just a few moments to fill out the warranty registration online at
www.lindsaymfg.com/registration.
www.lindsaymfg.com 22