Replacing 4V Halogen Bulb; Maintenance And Servicing; Cleaning, Maintenance, And Lubrication - Harbor Freight Tools LuminarWORK 69286 Owner's Manual & Safety Instructions

Maintenance and Servicing

procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy REVENT SERIOUS INJUR FROM A REVENT SERIOUS INJURy
Turn the Trigger of the tool off and unplug the Adapter before performing
any inspection, maintenance, or cleaning procedures.

cleaning, Maintenance, and Lubrication

1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
Replacing the 4V Halogen Bulb: Replacing the 4V Halogen Bulb:
Note: To prevent hand-oil contamination, DO NOT touch the Halogen Bulb with
bare hands. Use a lint free, soft, clean rag to handle the Bulb.
Note: Unplug all wire connections by holding the connectors and pulling. Unplug all wire connections by holding the connectors and pulling.
Do not pull the wires apart by tugging on the wires.
1. Slide the Ring Cover off of the Housing.
2. Unthread the two screws holding the Ring in place.
3. Carefully remove the Ring, the glass Lens and the Reflector.
4. Unplug the black wire (negative) from the bottom of the Reflector.
5. Pull back the casing on the red wire (positive) connection,
then unplug the bulb wire from the red wire connection.
6. Unhook the ends of the Spring Clip and
remove the clip and old Bulb.
7. Place the new Bulb into the Reflector Bowl opening
and slide the Spring clip under the Tab, over the
Bulb Flange, then lock the ends into the "T" Slot.
8. Plug the red and black wires back in place, sliding
the casing over the red wire connection.
9. Reassemble the Reflector, Lens, Ring and Ring Cover.
Position Spring Clip Black Wire
as shown below
Connection
Flange
"T" slot
Page 6
y y FROM A ccIDENTAL OpERATION:
Tab
Press
these
ends into
"T" Slot
Figure E
For technical questions, please call 1-800-444-3353.
2. AFTER USE, wipe external surfaces
of the Spotlight with clean cloth.
3. Store the Adapter and tool in a dry,
indoor area out of reach of children.
Housing
Housing Housing Housing
Casing Red Wire
Bulb before locking Spring Clip in place
Ring Cover
Ring Ring
Lens
Reflector
Bulb
Screw
Spring Clip
Figure c
Black Wire
Reflector
Bulb Wire
Figure D
Bulb properly installed
Item 69286