Asus P5Q Deluxe Manual page 159

Using Drive Xpert funcition in BIOS setup environment
You may use Drive Xpert function in BIOS setup environment. Enter BIOS setup
by presssing DEL key after powering on. Go to Advanced menu, select Onboard
Device Configuration, then press <Enter>.
Advanced
Onboard Device Configuration
High Definition Audio
Front Panel Type
Marvell IDE
PCIE IDE Boot ROM
Marvell LAN1
LAN Boot ROM
Marvell LAN2
LAN Boot ROM
Agere Firewire 1394
Drive Xpert Mode Update
Update to Super Speed
Update to EZ Backup
Update to Normal Mode
Serial Port1 Address
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Drive Xpert Mode Update [Current setting]
Set this item to [Mode change] to show further settings of the Drive Xpert
function. Configuration options: [Current setting] [Mode change]
Update To Super Speed [Press Enter]
This item appears only when the Drive Xpert Mode Update item is set to [Mode
change] and allows you to use Super Speed function. Plug two identical SATA hard
drives in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on
the motherboard and press the <Enter> key.
Update To EZ Backup [Press Enter]
This item appears only when the
change] and allows you to use and allows you to use
drives in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on
the motherboard and press the <Enter> key.
Make necessary backup before using the Drive Xpert function:
• All original data of the hard drive connected to the SATA_E2 (white, port 1)
connector on the motherboard will be erased for EZ Backup setup
• All original data of the two hard drives will be erased for Super Speed
setup.
Update To Normal Mode [Press Enter]
This item appears only when the
change] and allows you to use the SATA_E1 (orange, port 0) and SATA_E2 (white, and allows you to use the SATA_E1 (orange, port 0) and SATA_E2 (white,
port 1) connectors as normal SATA connectors.
ASUS P5Q Deluxe
BIOS SETUP UTILITY
[Enabled]
[HD Audio]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[Disabled]
[Enabled]
[Mode change]
[Press Enter]
[Press Enter]
[Press Enter]
[3F8/IRQ4]
Mode change] to show further settings of the Drive Xpert ] to show further settings of the Drive Xpert
and press the <Enter> key.
when the Drive Xpert Mode Update item is set to [Mode
allows you to use EZ Backup function. Plug two identical SATA hard
SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on
and press the <Enter> key.
when the Drive Xpert Mode Update item is set to [Mode
the SATA_E1 (orange, port 0) and SATA_E2 (white,
as normal SATA connectors.
Enable or Disable
High Definition Audio
Controller
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
SATA_E2 (white, port 1) connectors on
. Plug two identical SATA hard
connectors on connectors on
4-49