Chevrolet SS Sedan 2015 Owner's Manual page 356

10. Inflate the tire to the
recommended inflation
pressure using the pressure
gauge (2). The recommended
inflation pressure can be found
on the Tire and Loading
Information label. See Tire
Pressure on page 10-42.
The pressure gauge (2) may
read higher than the actual tire
pressure while the compressor
is on. Turn the compressor off
to get an accurate reading. The
compressor may be turned on/
off until the correct pressure is
reached.
11. Switch the on/off switch (1) to
the O position.
Be careful while handling the
tire sealant and compressor kit
as it could be warm after
usage.
12. Unplug the power plug (6) and
the air only hose (4).
13. Replace the tire valve
stem cap.
14. Place the equipment in the
original storage location in the
vehicle.
Removal and Installation of the
Sealant Canister
After repairing a tire, replace the tire
sealant canister.
To remove the sealant canister:
1. Unlock the air only hose (4) from
the tire sealant canister (3) by
pulling up on the lever.
2. Pull the air only hose (4) from
the tire sealant canister (3).
3. Unwrap the sealant/air hose (5)
from the air compressor.
Vehicle Care
4. Turn the sealant canister (3)
counterclockwise so the sealant/
air hose (5) is aligned with the
slot in the compressor.
5. Lift the tire sealant canister (3)
from the compressor and
replace with a new tire sealant
canister. See your dealer for
more information.
6. Dispose of the tire sealant
canister at your dealer or in
accordance with local or State
codes and practices.
10-63