Using The Air Cleaner And Humidifier; Using The Drying Mode Function; Powering The Unit On/Off; Adjusting The Control Panel Brightness - Brookstone Pure-Ion Bedroom User Manual

have been bent and touch each other.
• If you find that the collection plates in the FILTER are not completely clean after
one dishwasher cycle, increase the wash cycle time or wash them a second time.
• It is safe to use standard dishwasher soap.
• If hand washing, rinse the FILTER' s collection plates in your sink to remove loose
debris. Submerge the entire FILTER in warm, soapy water and allow it to soak for
15 minutes. Rinse with cold water.
• You may use a small scrub brush to clean in between the collection plates, but
take care not to bend them.
• If you do not allow the FILTER to completely dry, you may hear a crackling noise
during use. If this occurs, remove the FILTER and dry it completely before use.

USING THE DRYING MODE FUNCTION

IMPORTANT: The Drying Mode function should only be used to remove possible
minor residual moisture. DO NOT use the Drying Mode to dry a soaking wet
FILTER, as this may damage the unit.
1. With the unit off and a clean FILTER in the unit, press and hold the FAN
SPEED and TIMER buttons for 3 seconds. The unit will run the Fans on the
Turbo setting with no electrical charge for 40 minutes. The Turbo Fan Speed
LED will blink during the Drying Mode.
2. After 40 minutes have passed, the unit will exit out of the Drying Mode and
will turn off.
Note: To exit out of the Drying Mode before 40 minutes have passed, press the
POWER button. The Drying Mode will be stopped and the unit will turn off.
12

USING THE AIR CLEANER AND HUMIDIFIER

POWERING THE UNIT ON/OFF

1. Insert the power cord into an electrical outlet.
2. Press the POWER button to turn the unit on.
3. Press the POWER button to turn the unit off.

ADJUSTING THE CONTROL PANEL BRIGHTNESS

1. The control panel has four brightness levels: High, Medium, Low and Off.
2. To adjust the brightness level, press and hold the POWER button (when the
unit is powered on) for 3 seconds. The control panel will cycle through
the four brightness levels.
3. Release the POWER button when the control panel displays your desired
brightness level.
Note: If the brightness level is set to Medium, Low or Off, when any button is
pressed, the brightness level will default to High for 5 seconds.

SELECTING AIR CLEANER FAN SPEED

Press the FAN SPEED button to choose between Whisper, Low, Medium, High and
Turbo Fan Speeds. An LED will denote the selected Fan Speed.
Note: The FAN and the HUMIDIFIER can be used simultaneously or separately.
illuminates.
9