Setting Up The Unit; Disinfecting The Water Tanks - Brookstone Pure-Ion Bedroom User Manual

SETTING UP THE UNIT

IMPORTANT: Placement of this unit MUST BE AT LEAST 24" from the wall,
furniture or other appliances.
1. Remove all tape and protective wrap from the unit. Ensure the foam block on
top of the filter under the FILTER COMPARTMENT DOOR is removed before
use.
2. Place the unit on a level surface, keeping it at least 24" away from the wall,
furniture or other appliances.
3. Position the unit so the cleaner air flows to your desired location.
4. Always unplug the unit before filling the WATER TANKS. Lift and remove each
WATER TANK from the unit and turn upside down. Unscrew the WATER TANK
CAP and fill each WATER TANK with water. For best results use distilled water.
5. Replace the WATER TANK CAP on each WATER TANK and turn the WATER
TANK upright to check for leaks. If any water drips from the WATER TANK
CAP, remove and re-tighten.
6. Replace the WATER TANKS on the unit.
Note:
When moving the unit to a new location, turn the unit off, unplug from the
electrical outlet and remove the WATER TANKS. Keep the unit level as there may
be water in the WATER RESERVOIR. Replace the WATER TANKS once the unit
is on a level surface.
8
HUMIDIFIER MAINTENANCE
IMPORTANT! RISK OF ELECTRIC SHOCK. Always unplug the unit before
cleaning the WATER TANKS and the WATER RESERVOIR.
CLEANING THE WATER TANKS
The WATER TANKS should be cleaned on a weekly basis.
1. Power the unit OFF and disconnect from the electrical outlet.
2. Lift and remove each WATER TANK from the unit and turn upside down.
Unscrew the WATER TANK CAPs.
3. Drain the water from the WATER TANKS and thoroughly rinse with warm water.
4. Wipe clean and dry with a clean cloth or paper towel.

DISINFECTING THE WATER TANKS

The WATER TANKS should be disinfected on a monthly basis.
1. Power the unit OFF and disconnect from the electrical outlet.
2. Lift and remove each WATER TANK from the unit and turn upside down.
Unscrew the WATER TANK CAPS.
3. Fill each WATER TANK with one half gallon of water and one half tablespoon
of chlorine bleach. Let the solution stand for 20 minutes, swishing every few
minutes to wet all surfaces.
4. Empty each WATER TANK after 20 minutes and rinse with warm water until no
bleach smell is detected.
5. Dry with a clean cloth or paper towel.
13