Advertisement
Adjust the mounting rails to equal heights, and then securely tighten the mounting
screws.
Caution: Never use a power screwdriver to tighten the mounting screws, or the dis-
play may be damaged.
Step 4: Hang the Display
With the tilt mechanism fully open, lift
the display into position in front of the
wall plate. Align the slots on the
mounting rails with the rods on the
wall plate, and then lower the display
onto the rods. (Fig. 7)
Caution: Make sure that both
rods are fully engaged before re-
leasing the display.
Important: Prior to lifting the dis-
play, make sure that the lock is in the
open position. (Fig. 8)
Fig. 8
Once in place, the lateral position of display can be
adjusted by gently sliding it along the rods.
6
Fig. 7
Step 1: Determine the Mounting Location
Measure the width and height dimensions of the display.
Mark the wall with the desired location for the display.
Important: Make sure that there is adequate mounting space available for
mounting the display, considering the display dimensions.
Step 2: Mount the Wall Plate
Using an electronic stud finder, locate the center of the wooden stud at the desired
mounting location. Mark the stud center position directly onto the wall. To optimize
display placement, the Wall Plate can be offset up to 6" (+/-3") from stud center in
3/4" increments, by utilizing the offset mounting holes. (Fig. 1)
Fig. 1
Locate the supplied mounting guide. (Fig. 2)
Fold the dust collector along the marked lines:
a.
Fold main channel up.
b.
Crease and fold the tab sections inward.
c.
Fold outer portion of tab around the back of the guide, and then insert
tab into slot.
3
Fig. 2
Advertisement
