Download Print this page

Technical Data; How To Use - HACE MJS-500 Instruction Manual

Ultrasonic humidifier

Advertisement

1.Technical data

Model: MJS-500 MJS-400
Rated voltage: 220V-240V - 50Hz
Rated power: 30W
Tankage: 5L
Mist: ≥260mL/H
Noise: <35dB

2. How to use

MJS-500
1)Put the humidifier on a suitable place and take off the tank. Unscrew the cover and fill the tank with
clean tap water or distilled water.
2)Screw on the cover. Dry the water on the outside of the tank. Put the tank back to the humidifier.
3) On/Off: Connected with power (220V-240V - 50Hz), turn on the Power Switch, power indicator light
turns green and humidifier starts to work. Turn the Mist knob to control the mist. The volume of mist will
decrease when you turn the knob left and vice versa.
4)The power will be automatically cut off and power indicator light turns red when the tank is short of
water. Please disconnect the power and refill the tank with water.
MJS-400
1)Put the humidifier on a suitable place and take off the tank. Unscrew the cover and fill the tank with
clean tap water or distilled water.
2)Screw on the cover. Dry the water on the outside of the tank. Put the tank back to the humidifier.
3) On/Off: Connected with power (220-240V- 50Hz), turn on the Power Switch, the buzzer beeps once.
The humidifier enters standby mode with the flashing of the indicator. Turn on by pressing On/Off button
and the standby indicator blacks out while the mist setting is S2. Turn off by pressing the On/Off button
again.
4)Mist control: There are four settings: S1<S2<S3<S4. The display shows the setting at first and water-
flow later. If you set the mist during humidifying, the humidifying will be stopped.
5)Humidifying: Range of humidity setting: from 40% to 70% RH. One press, 1% added. One long press,
5% added. The humidifying stops when the environmental humidity is the same as the setting. The hu-
midifying starts when environmental humidity is lower than the setting. The display shows environmen-
tal humidity and the setting by turns. The mist will be set automatically according to the environmental
humidity when it is humidifying.
6)Timer: Range of time setting: from 1 to 12 Hours. The humidifier will be turned off automatically when
the time is over. One press, one hour added. The time will be counted down after setting.
7)Water short: water-short indicator when it is short of water and water-flow light shine. No mist is gen-
erated. Please turn off the humidifier and turn it on after adding water. If no water added, the humidifier
will be turned off automatically one minute later.
8) Temperature (only for MJS-400)The display shows the environmental temperature. and if the time be-
ing counted down, the display shows the time left and the temperature by turns.
Caution: The showed environmental humidity and temperature may not be exactly right, which are refer-
ences for humidifying only. Please do not apply them to other purposes.

Advertisement

loading

This manual is also suitable for:

Mjs-400