If you are going to install a new HDD rather than replacing the default one,
proceed to Step 4.
Removing the HDD Carrier from the 1450R Computer
3. Remove the HDD module from its carrier.
a. Remove the four screws from the bottom of the HDD assembly carrier.
b. Detach the carrier from the HDD module.
4. Install the new HDD module to its carrier.
a. Lay the HDD module with the printed circuit board (PCB) side up.
b. Fasten the HDD carrier over the module, then secure it with the four screws.
Removing the HDD Carrier from the 750R Computer
Publication 6177R-IN002B-EN-P - November 2009
Hard Disk Drive (HDD)
7