Install The Hard Disk Drive; Remove The Side Cover On The 750R Computer - AB Quality 6189V-35HDDST80 Installation Instructions Manual

Install the Hard Disk Drive

You can replace the default hard disk drive (HDD) or install an HDD in the empty HDD bay.
The computers have two HDD bays for installing SATA HDD modules.

Remove the Side Cover on the 750R Computer

To remove the HDD carrier, you must first remove the security screw inside the computer.
The 1450R does not ship with a security screw because the front door is lockable.
1. Perform the pre-installation procedure.
2. Unfasten the side cover from the system chassis by removing the two screws located
on the rear edge of the side cover.
3. Slide the cover back about 1.5 cm (0.5 in.), then pull the panel away from the chassis.
4. Remove the screw that secures the HDD to the chassis.
Removing the security screw makes the HDD
carrier front accessible.
Removing the Side Cover on the 750R Computer
Publication 6177R-IN002B-EN-P - November 2009
Hard Disk Drive (HDD) 5