G-Shock Gravity Defier GW-A1100 Quick Operation Manual

Gravity Defier
GW-A1100
Direction Measurement Function-equipped.
The Pilot's Watch Evolves Even Further.
Tough Triple G Resist structure protecting against
3 types of gravitational acceleration
Direction measurement function employing a newly
developed miniature magnetic sensor
World Time with direct UTC display
Series' largest 35.4mm wide face design
Durable, high-transparency sapphire crystal with
non-reflective coating
First use of carbon-fibre material for
second hand fabrication
Oversized crown with superior grip
Operation from the Timekeeping Mode
Operations are performed using the watch's crown and the three
buttons indicated by the letters
Hour Hand
Hour Hand
(24-hour format)
Mode Dial Hand
Day of week display
in Timekeeping Mode
C
Using the Crown
This watch has a screw-lock crown.
Locking the crown
1 Be sure the crown is pushed in (see "Pulling out, rotating and pushing in
the crown" at right). *Note that attempting to lock the crown when it is
not pushed in can cause unintended watch operation.
2
Rotate the crown until the groove is aligned with mark 1.
3 While holding down the crown
with mark 2.
4
Pull gently on the crown to make sure it is locked securely in place.
Quick Operation Guide
A C
, B and in this guide.
Second Hand
Minute Hand
A
Crown
Day
B
Mark 1
Groove
, rotate it to the right until the groove is aligned
Selecting a Mode
The mode changes with each press of
C Timekeeping Mode
AL
Alarm Mode
C
TR
Timer Mode
Important!
C
Holding down in any mode returns the display to the Timekeeping Mode.
You should normally have the crown locked during daily use. Leaving the crown
Mark 2
unlocked creates the risk of unintended operations or even damage due to impact.
Groove
Unlocking the crown
Rotate the crown until the groove is aligned with mark 1.
Pulling out, rotating and pushing in the crown
Pull out Rotate
Module 5311
No.
C
.
C
WT
World Time Mode
C
Stopwatch Mode
C
Push in
Important!
Unlock the crown before
performing any of these operations.
ST