Clean Your Electric Kettle Before First Use; Using Your Cordless Electric Kettle - Sunbeam BVSBKT1703 Series User Manual

Clean your electric kettle before first use

1. Wash the inside of the kettle and lid with mild detergent and
water. Rinse each thoroughly. Do not immerse the kettle or
power base in water or any other liquid. These items are not
dishwasher safe.
2. Fill the electric kettle with fresh water to the "MAX" water
level mark on water window. Boil the water, following the
directions below for use of your specific kettle.
3. When the water and unit have cooled, discard the water. Rinse
with cold water and repeat.
4. Your electric kettle is now ready for use.

Using your Cordless Electric Kettle

1. Position the power base on a flat, heat resistant surface, as
close as possible to a power outlet.
2. Follow cord routing in power base according to exit patterns.
Proper cord routing will result in the power base laying flat
when kettle is placed in base. DO not operate kettle if power
base is not flat. Remove kettle from power base and repeat
cord placement instructions.
3. To fill with water, open the lid. Fill the kettle with water up to
the "MAX" water level mark. NOTE: Do not exceed the "MAX"
water level mark indicated on the water window.
4. Plug the electric cord into an electric outlet. Turn the switch
ON by pushing up on the on/off switch. The on/off light will
light to indicate the unit is on. The water will heat and the
electric kettle will switch off automatically when the water has
boiled. NOTE: Ensure the ON/OFF switch is clear of obstructions
and the lid is firmly closed. The electric kettle will not turn off
automatically if the ON/OFF switch is constrained, or if the lid is left
open.
5. Carefully lift the kettle from the power base and pour the
boiling water.
NOTE: The kettle will not re-boil until the on/off switch is again
switched ON. Wait 15-20 seconds, allowing kettle to cool down,
then swtich ON.
setting up
4