Standard Accessories; Optional Accessories (Sold Separately); Battery Removal/Installation - Hitachi DS 14DSAL Handing Instructions

STANDARD ACCESSORIES

1 Plus driver bit (No. 2) .............................. 1
2 Charger (UC18YGSL or UC18YRSL) ..... 1
DS18DSAL
3 Battery (BSL1830 or BSL1815X) ............ 2
4 Plastic case ............................................ 1
5 Battery cover .......................................... 1
1 Plus driver bit (No. 2) .............................. 1
2 Charger (UC18YGSL or UC18YRSL) ..... 1
DS14DSAL 3 Battery (BSL1430 or BSL1415X) ............ 2
4 Plastic case ............................................ 1
5 Battery cover .......................................... 1
Standard accessories are subject to change without notice.

OPTIONAL ACCESSORIES (sold separately)

1. Battery
(BSL1430) (BSL1415X)
Optional accessories are subject to change without notice.
Before
charging
While
charging
The pilot lamp
lights or blinks
Charging
in red.
complete
Charging
impossible
The pilot lamp Overheat
lights in green. standby
(2) Regarding the temperatures of the rechargeable battery
The temperatures for rechargeable batteries are as
shown in Table 2, and batteries that have become hot
should be cooled for a while before being recharged.
(BSL1830) (BSL1815X)
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for
Blinks 0.5 seconds. (off for 0.5 seconds)
Lights continuously
Lights
Lights for 0.5 seconds. Does not light for
Blinks 0.5 seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for
Flickers 0.1 seconds. (off for 0.1 seconds)
Lights continuously
Lights
APPLICATIONS
○ Driving and removing of machine screws, wood screws,
tapping screws, etc.
○ Drilling of various metals.
○ Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch (2 pcs.)
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as follows.
<UC18YRSL>
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's pilot
lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the line is
visible, as shown in Fig. 3, 4.
3. Charging.
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
Table 1
Table 2 Recharging ranges of batteries
Rechargeable batteries
BSL1430, BSL1415X,
BSL1830, BSL1815X
Malfunction in the battery or
the charger
Battery overheated.
Unable to charge.
(Charging will commence
when battery cools)
Temperatures at
which the battery
can be recharged
0°C – 50°C
9